Robotronics Buzz E Provozní pokyny stáhnout pdf (Strana 18)

Voice System

CHAPTER 3 Voice System

The Voice System consists of two separate communication links. One link transmits the

operator's voice to the robot. When you speak into the headset mic, this audio goes to a

transmitter on your belt. This audio is transmitted to a receiver in the robot. The audio signal

then goes from the receiver through a mixing circuit on the main board. It is then is fed into the

amplifier which amplifies the signal through the robot's speakers.

The second voice link transmits the audio detected by the Mic element (located in the front of

the robot) to the 151 receiver (which is worn by the operator). This is amplified and sent to the

speaker in the operator's headset.

Important: The operator’s transmitter and receiver should be kept as far separate as possible,

such as on opposite sides of the operator's waist. Do not attach the units together, this may

cause interference effects. The antennas should not be wrapped around each other or around

the headset wire but should hang freely.

Location of Voice Units

Voice Transmitter- Operator wears

Voice Receiver- On the main electronics box in the lower robot.

151 Transmitter- On the frame in the robot. The robot mic connects to it.

151 Receiver- Operator wears

Operator’s Voice Transmitter, Receiver, and Headset

3.5 mm headphones

Plu

151 Receiver

Transmitter

3.5 mm

mic plug

On some models the mic

plug is a 3 Pin Mini XLR

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 60 61

Žádné komentáře

Robotronics Buzz E Provozní pokyny Strana 18